HP Jetdirect 3000w NFC/Wireless Accessory - Installation Guide
4
NOTE: To ensure printer compatibility and maintain regulatory
1. Ensure the Jetdirect 3000w accessory is disconnected from
2. Go to www.hp.com/go/FutureSmart and select .
3. Find your printer and select the link.
4.
5. Follow the instructions for installing the Jetdirect 3000w
accessory below.
Steps A1-A9.
Steps B1-B6.
Step A1 and B1: Turn OFF the power to the printer.
Step A2-A3: Locate and open the Hardware Integration Pocket
(HIP2) on the printer. The HIP2 location may vary by printer. Refer to
your printer user guide if needed.
The HIP2 is covered by a rectangular cover that is retained by clips
Step A4: To install in the HIP2, connect the white connector on the
short USB cable to the HP Jetdirect 3000w.
Step A5: Connect the USB connector on the short USB cable to the
socket in the printer’s HIP2.
Step A6, A7:
into the HIP2 recess. Then gently push the HP Jetdirect 3000w onto
the rounded clips so that it is held securely in place in the HIP2.
Step B2: To install outside the printer, connect the white connector
on the long USB cable to the HP Jetdirect 3000w.
Step B3: Push the long USB cable into the slot on the accessory
3000w to the accessory cover.
Step B4: Attach the fastener strips (optional) to the bottom of the
3000w. Remove the backing paper in order to attach the bottom set
of fastener strips to the top of the printer (Step B5). Place the 3000w
on the printer. Connect the USB connector on the long USB cable to
the USB accessory port, usually located at the back of the printer.
Step A9 and B6:
be shown under the section of the
printer’s . A wireless network
icon will also appear on the printer’s control panel.
NOTE:
information at www.hp.com/support/jd3000w.
For more information on mobile printing, go to:
www.hp.com/go/MobilePrinting
www.hp.com/go/WirelessPrinting
www.hp.com/support/jd3000w
REMARQUE: pour garantir la compatibilité de l’imprimante et
1.
2. www.hp.com/go/FutureSmart
(Mettre à niveau maintenant).
3.
Téléchargement du micrologiciel.
4.
5.
ci-dessous.
les
ci-dessous.
:
:
matériel (HIP2) sur l’imprimante. L’emplacement du module HIP2
l’utilisateur de l’imprimante si nécessaire.
: pour installer l’accessoire dans le module HIP2,
:
socket situé dans le module HIP2 de l’imprimante.
:
de le maintenir fermement en place dans le module HIP2.
: pour installer l’accessoire en dehors de l’imprimante,
:
:
).
:
la section Modes d’impression et options installés des pages
de l’imprimante. Une icône de réseau
REMARQUE:www.hp.com/support/jd3000w pour
obtenir des informations supplémentaires concernant l’installation,
www.hp.com/go/MobilePrinting
www.hp.com/go/WirelessPrinting
www.hp.com/support/jd3000w
EN FR