HP MFP Analog Fax Accessory-Warranty and Legal Guide

電信（傳真）聲明
傳真線聲明
產品不一定有隨附傳真線。如果未隨附，請僅使用 No. 26 AWG 或更高規格的電信線纜，以降低發生火
災的風險。
歐盟電信作業聲明
印表機符合適用 EU 指令，並具有 CE 標誌。如需詳細資訊，請參閱本手冊另一節中的 EU 一致性聲明
（由製造廠商發出）。
讓具該功能的印表機連接到類比公用交換電信網路 (PSTN)：
由於歐洲各國 PSTN 之間的差異，本產品不保證在每個 PSTN 終端點都能無條件順利運作。網路相容性
取決於客戶在準備連接至 PSTN 時所選擇的正確設定。請按照使用者手冊中提供的指示進行。如果您遭
遇網路相容性問題，請聯絡您的設備供應商或是作業所在國家
/地區的 HP Inc. 服務中心。連接至 PSTN
終端點可能需要滿足當地 PSTN 業者提出的額外需求。
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item
will work correctly in all respects with another item of Telepermitted equipment of a dierent make or model, nor
does it imply that any product is compatible with all of Telecom’s network services.
This equipment may not provide for the eective hand-over of a call to another device connected to the same
line.
This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New
Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back
of this equipment is a label that contains, among other information, a product identier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not
all, areas, the sum of the RENs should not exceed ve (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company to determine the
maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed
to be connected to the telephone network or premises wiring using a compatible modular jack, which is Part 68
compliant. This equipment cannot be used on telephone company-provided coin service. Connection to Party
Line Service is subject to state taris.
ZHTW
電信（傳真）聲明
29