HP EliteBook Folio 1040 G1 Notebook PC Maintenance and Service Guide

SSD drive
Description Spare part number
Solid-state drive
256-GB, SATA III 746906-001
180-GB, SATA III 746908-001
180-GB, SATA III, self-encrypting 763997-001
128-GB, SATA III 746907-001
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
Bottom cover on page 39).
5. Disconnect the battery (see
Battery on page 44).
Remove the SSD:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: mSATA drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to reassemble and install the mSATA drive.
46 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts