HP EliteBook Folio 1040 G1 Notebook PC Maintenance and Service Guide

Power connector
Description Spare part number
Power connector 749612-001
Before removing the power connector, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Bottom cover (see
Bottom cover on page 39)
5. Remove the battery (see
Battery on page 44), and then remove the following components:
Remove the power connector:
1. Disconnect the power connector cable from the system board (1).
2. Remove the Phillips PM2.0×3.0 screw (2) that secures the power connector cable to the computer.
3. Lift the power connector from the computer (3).
Reverse this procedure to install the power connector.
Component replacement procedures 61