Product Data Sheet / Brochure

provides independent primary and secondary operating system files for backup while upgrading or fine-tuning the switch
configuration
Multiple configuration files
can be stored to the flash image
HP unified core-to-edge features
HP ProVision portfolio-common feature implementation allows faster solution deployment
NEW Comware-compatible CLI
Comware-compatible CLI
bridges the experience of HP Comware CLI users who are using the HP ProVision software CLI
Display and fundamental Comware CLI commands
are embedded in the switch CLI as native commands; display output is formatted as on Comware-based switches, and
fundamental commands provide a Comware-familiar initial switch setup
Configuration Comware CLI commands
when Comware commands are entered, CLI help is elicited to formulate the correct ProVision software CLI command
Connectivity
High-density port connectivity
provides 12 interface module slots, up to 288 wire-speed 10/100/1000 PoE-enabled ports, or 96 10-GbE ports per system
IEEE 802.3az Energy Efficient Ethernet
lowers power consumption in periods of low-link usage (supported on v2 zl 10/100/1000 and 10/100 modules)
IEEE 802.3af Power over Ethernet (PoE)
provides up to 15.4 W per port to IEEE 802.3af-compliant PoE-powered devices such as IP phones, wireless access points, and
security cameras
IEEE 802.3at Power Over Ethernet Plus
provides up to 30 W per port to IEEE 802.3 for PoE-/PoE+-powered devices such as video IP phones, IEEE 802.11n wireless
access points, and advanced pan/zoom/tilt security cameras
Jumbo frames
on Gigabit Ethernet and 10-Gigabit Ethernet ports, jumbo frames allow high-performance remote backup and disaster-recovery
services
HP unified core-to-edge hardware
HP ProVision family-common interface and service modules, Gigabit optics/10 GbE transceivers, and power supplies enable
sparing simplicity
Prestandard PoE support
detects and provides power to prestandard PoE devices; see the list of supported devices in the product FAQs at
www.hp.com/networking
Auto-MDIX
automatically adjusts for straight-through or crossover cables on all 10/100 and 10/100/1000 ports
IPv6
IPv6 host
enables switches to be managed in an IPv6 network
Dual stack (IPv4 and IPv6)
transitions from IPv4 to IPv6, supporting connectivity for both
protocols
MLD snooping
forwards IPv6 multicast traffic to the appropriate interface
IPv6 ACL/QoS
supports ACL and QoS for IPv6 network traffic
IPv6 routing
supports static and OSPFv3 routing protocols
QuickSpecs
HP 8200 zl Switch Series
Overview
DA - 12862 Worldwide — Version 38 — February 17, 2014 Page 6