Datasheet

QuickSpecs
HP 2530 Switch Series
Technical Specifications
c04111414 - DA – 14447 Worldwide — Version 7 —August 18, 2014
Page 20
HP 2530-48G-PoE+
Switch (J9772A)
I/O ports and slots
48 RJ-45 autosensing 10/100/1000 PoE+ ports (IEEE 802.3 Type 10BASE-T,
IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T, IEEE 802.3at
PoE+); Media Type: Auto-MDIX; Duplex: 10BASE-T/100BASE-TX: half or full;
1000BASE-T: full only
4 fixed Gigabit Ethernet SFP ports
Additional ports and
slots
1 dual-personality (RJ-45 or USB micro-B) serial console port
Physical characteristics
Dimensions
17.44(w) x 13.00(d) x 1.75(h) in (44.3 x
32.26 x 4.45 cm) (1U height)
Weight
10.4 lb (4.72 kg)
Memory and processor
Processor
ARM9E @ 800 MHz, 128 MB flash, 256 MB
DDR3 DIMM; packet buffer size: 3 MB
dynamically allocated
Mounting and enclosure
Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-
mounting kit available); horizontal surface mounting; wall mounting
Performance
IPv6 Ready Certified
100 Mb Latency
< 7.4 µs (LIFO 64-byte packets)
1000 Mb Latency
< 2.3 µs (LIFO 64-byte packets)
Throughput
77.3 Mpps (64-byte packets)
Switching capacity
104 Gbps
MAC address table size
16000 entries
Environment
Operating temperature
32°F to 113°F (0°C to 45°C)
Operating relative humidity
15% to 95% @ 104°F (40°C), noncondensing
Non-operating/
Storage temperature
-40°F to 158°F (-40°C to 70°C)
Non-operating/Storage
relative humidity
15% to 90% @ 149°F (65°C), noncondensing
Altitude
up to 10,000 ft (3 km)
Acoustic
Power: 43.6 dB, Pressure: 33.6 dB
Electrical characteristics
Frequency
50/60 Hz
Maximum heat dissipation
236 BTU/hr (248.98 kJ/hr), (switch only: 236
BTU/hr; combined switch + max. PoE
devices: 1624 BTU/hr)
AC voltage
100 - 127 / 200 - 240 VAC
Current
5.8/2.9 A
Maximum power rating
476 W
Idle power
40.1 W
PoE power
382 W
Notes
Idle power is the actual power consumption
of the device with no ports connected.
Maximum power rating and maximum heat
dissipation are the worst-case theoretical
maximum numbers provided for planning
the infrastructure with fully loaded PoE (if
equipped), 100% traffic, all ports plugged in,
and all modules populated.
PoE power is the total power budget
available to all PoE ports.