Datasheet

QuickSpecs
HP 2530 Switch Series
Technical Specifications
c04111414 - DA – 14447 Worldwide — Version 7 —August 18, 2014
Page 42
Switch (J9855A)
802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T); Duplex:
10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only
2 SFP+ fixed 1000/10000 SFP+ ports
Additional ports and slots
1 dual-personality (RJ-45 or USB micro-B) serial console port
Physical characteristics
Dimensions
17.44(w) x 10.00(d) x 1.75(h) in (44.3 x 25.4 x
4.45 cm) (1U height)
Weight
7.1 lb (3.08 kg)
Memory and processor
Processor
ARM9E @ 800 MHz, 128 MB flash, 256 MB DDR3
DIMM; packet buffer size: 3 MB dynamically
allocated
Mounting and enclosure
Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-
mounting kit available); horizontal surface mounting; wall mounting
Performance
IPv6 Ready Certified
100 Mb Latency
< 7.3 µs (LIFO 64-byte packets)
1000 Mb Latency
< 2.7 µs (LIFO 64-byte packets)
10 Gbps Latency
< 4.0 µs (LIFO 64-byte packets)
Throughput
101 Mpps (64-byte packets)
Switching capacity
136 Gbps
MAC address table size
16000 entries
Environment
Operating temperature
32°F to 113°F (0°C to 45°C)
Operating relative
humidity
15% to 95% @ 104°F (40°C), noncondensing
Non-operating/
Storage temperature
-40°F to 158°F (-40°C to 70°C)
Non-operating/Storage
relative humidity
15% to 90% @ 149°F (65°C), noncondensing
Altitude
up to 10,000 ft (3 km)
Acoustic
Power: 32.2 dB, Pressure: 25.6 dB
Electrical characteristics
Frequency
50/60 Hz
Achieved Miercom Certified Green Award
Maximum heat
dissipation
189 BTU/hr (199.4 kJ/hr)
AC voltage
100 - 127 / 200 - 240 VAC
Current
0.9/0.5 A
Maximum power rating
55.1 W
Idle power
33.3 W
Notes
Idle power is the actual power consumption of
the device with no ports connected.
Maximum power rating and maximum heat
dissipation are the worst-case theoretical
maximum numbers provided for planning the
infrastructure with fully loaded PoE (if
equipped), 100% traffic, all ports plugged in,
and all modules populated.
PoE power is the total power budget available
to all PoE ports.
Safety
UL 60950-1; CAN/CSA 22.2 No. 60950-1; EN 60825; IEC 60950-1; EN
60950-1