Datasheet
QuickSpecs
HP 2530 Switch Series
Accessory Product Details
c04111414 - DA – 14447 Worldwide — Version 7 —August 18, 2014
Page 53
Gigabit solution up to 100
m on Category 5 or better
cable
Nonoperating/Storage temperature: -40°F to 185°F (-40°C to 85°C)
Nonoperating/Storage relative humidity: 0% to 95% @ 77°F (25°C),
noncondensing
Altitude: up to 10,000 ft. (3000 km)
Cabling
Cable type:
1000BASE-T: Category 5 (5E or better recommended), 100 Ù differential
4-pair unshielded twisted pair (UTP) or shielded twisted pair (STP)
balanced, complying with IEEE 802.3ab 1000BASE-T;
Maximum distance:
100 m
Notes
Power consumption is nominally 1 watt.
For supported platforms and minimum software requirements to support
this product, see the document titled "Support for the J8177C 1000Base-T
Mini-GBIC" on the "HP Mini-GBICs and SFPs" Manuals Web page.
The J8177C Gigabit copper mini-GBIC is not supported on dual-personality
ports.
The J8177C is capable of 100 Mb operation. This is supported on only the
HP ProCurve Switch 8200zl, 5400zl, and 6200yl Series using software
version K.12.21 or later. Use the "auto-100" port setting to enable 100 Mb
operation.
Important: Important: The earlier J8177B does not support 100 Mb
operation.
When used in the ProCurve Switch gl 20-Port 10/100/1000 Module
(J4908A), the J8177C mini-GBIC can be installed in either the upper or
lower mini-GBIC port, but will block access to the other port.
HP X410 1U Universal 4-post Rack Mounting Kit (J9583A)
Notes
The rack mounting kit supports the 1U, full width switches in the following switch series and the power
supply: V1810 Series, E2510 Series, E2520 Series, E2610 Series, E2810 Series, E2910 Series, E3500
Series, and the E620 Power Supply
This universal rack mounting kit is design to fit the following racks: HP 10K 10642, HP 10K 10842,
Panduit CN, Panduit CS, Wrightline Vantage S2, APC Netshelter 600mm, and APC Netshelter 800mm. It
may well fit many other brands and models too.
Services
Refer to the HP website at: www.hp.com/networking/services for details on the service-level
descriptions and product numbers. For details about services and response times in your area, please
contact your local HP sales office.
HP 2530 8-port Switch
Power Adapter Shelf
(J9820A)
Physical characteristics
6.75(w) x 5.25(d) x 1.75(h) in (17.15 x 13.34 x
4.45 cm) (1U height)
Weight
0.6 lb (0.27 kg)
Notes
The HP 2530 8-Port Switch Power Adapter Shelf is an accessory for the HP
2530 8-port switches. The shelf mounts on the back of the switch providing
a place to hold the external power adapter.
Services
Refer to the HP website at www.hp.com/networking/services for details on
the service-level descriptions and product numbers. For details about
services and response times in your area, please contact your local HP
sales office.