HP 15 Notebook PC - Maintenance and Service Guide

Power connector cable
Description Spare part number
Power connector cable (includes bracket) 732067-001
Before removing the power connector cable, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 28), and then remove the following components:
a. Optical drive (see Optical drive on page 33).
b. Service door (see Service door on page 29).
c. WLAN module (see WLAN module on page 31).
d. Memory module (see Memory module on page 30).
e. Keyboard (see Keyboard on page 38).
f. Top cover (see Top cover on page 40).
g. Hard drive (see Hard drive on page 44).
h. System board (see System board on page 52).
Remove the power connector board:
NOTE: The power connector bracket was removed when removing the system board.
1. Turn the system board upside down, with the front toward you.
2. Release the power connector from the clip built into the system board.
Component replacement procedures 63