HP 15 Notebook PC - Maintenance and Service Guide

Reverse this procedure to install the power connector cable.
Speakers
Description Spare part number
Speakers (include, speaker cable, and 4 rubber isolators) 732084-001
Before removing the speakers, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 28), and then remove the following components:
a. Optical drive (see Optical drive on page 33).
b. Service door (see Service door on page 29).
c. WLAN module (see WLAN module on page 31).
d. Memory module (see Memory module on page 30).
e. Keyboard (see Keyboard on page 38).
f. Top cover (see Top cover on page 40).
g. Hard drive (see Hard drive on page 44).
h. System board (see System board on page 52).
Remove the speakers:
▲
Remove the speakers by lifting up on the clip on the right side speaker and lifting the speakers. Carefully
and gently lift the speaker wire connecting the left and right speakers.
NOTE: The speaker connection cable was removed when removing the system board.
NOTE: The speakers include rubber isolators that are installed in the screw holes. These isolators are
crucial to the performance of the speakers.
64 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts