HP Point of Sale (POS) Peripherals Configuration Guide

Page 495 of 522
9.6 HP USB Barcode Scanner
Question: I am not sure the setting of the Barcode Scanner, how can I put the scanner back to the
factory default setting?
Answer: You can put the scanner back to factory default setting by scanning the following bar code:
Set All Defaults
Question: After scanning an item, I have to press the “Enter” to accept what was scanned in my
application.
Answer: You can change the behavior of the scan so that a carriage return is also transmitted after an
item is scanned. In order to change the behavior of the scanner, scan the following bar
codes in order that they appear below:
Scan Options
<Data><Suffix>
Enter
Question: After scanning an item my application needs a tab.
Answer: You can change the behavior of the scan so that a tab is also transmitted after an item is
scanned. In order to change the behavior of the scanner, scan the following bar codes in
order that they appear below: