Administrator's Guide

print jobs sent to the printer either from the server or from a client computer that has set up that
printer, includes a reset command at the beginning of the job.
Support Info
Configure links for support assistance. You can designate a support person and the phone number of
an administrator for this device, as well as URL addresses for Web-based product and technical
support.
Refresh Rate
Time period (in seconds) that the diagnostic pages are automatically updated. A value of zero (0)
disables the refresh rate.
Select Language
This item is displayed if the HP Jetdirect Web pages support multiple languages. You can also select
supported languages by using the language preference settings in your browser (see your browser's
Help).
To display supported non-English languages, you must enable cookies in your browser settings.
Security: Settings
In the SECURITY section, the Settings item provides access to the following tabs: Status (default),
Wizard, Restore Defaults. The available settings depend on your particular print server model.
Status
Select the Status tab to display the current security configuration settings of the print server. The
settings displayed depend on the features supported by the print server.
Wizard
NOTE: If you use HP Web Jetadmin to manage your devices, do not use this wizard. Instead, use
HP Web Jetadmin to configure your network security settings.
Select the Wizard tab to open the initial Wizard page. If prompted with security alerts, click Yes to
proceed.
The Wizard page identifies the current security level last configured on the print server. If a security
level was not configured, the security level is None. However, if HTTPS is required for access to the
networking pages, the default setting indicates Custom.
This page also allows you to run the HP Jetdirect Security Configuration Wizard to set or change the
current security level. This wizard guides you through the print server's security configuration settings
for your network. Click Start Wizard to run the wizard and open the Security Level page.
The optional configuration parameters presented by the wizard depend on your choice of security
level. For an overview, see
Table 4-15 Wizard Security Levels on page 91.
NOTE: If you improperly exit the wizard (for example, by failing to use the Cancel button), an
Operation Failed screen appears. If this occurs, wait approximately two minutes and restart the
wizard.
90 Chapter 4 HP Embedded Web Server (V.45.xx.nn.xx) ENWW