Administrator's Guide

Table 8-2 HP Jetdirect Configuration/General Information (continued)
Message Description
STATUS Current state of the HP Jetdirect print server.
I/O CARD READY, or READY Successfully connected to the network and is awaiting
data.
I/O CARD INITIALIZING, or INITIALIZING Initializing the network protocols. For more
information, see the status line for each protocol on the configuration page.
I/O CARD NOT READY, or ERROR Problem detected with the print server or its
configuration.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-13 Error messages on page 153.
DATA RATE DETECTED Specifies the network data rate depending on the type of network connection:
1–54 Mbps (Wireless 802.11bgn)
10 Mbs, 100 Mbps, 1000 Mbps (Wired Ethernet)
MODEL NUMBER Product number of the HP Jetdirect print server (for example, J7961G)
LINK CONFIG Specifies the active link communication mode:
802.11: Wireless 802.11bgn
10T HALF: 10 Mbps, half-duplex (wired port)
10T FULL: 10 Mbps, full-duplex (wired port)
100TX HALF: 100Mbps, half-duplex (wired port)
100TX FULL: 100Mbps, full-duplex (wired port)
HARDWARE ADDRESS The 12-digit hexadecimal network hardware (MAC) address of the HP Jetdirect print
server installed in the printer or device. This address is assigned by the manufacturer.
PORT SELECT (Ethernet only) Specifies the port detected for use on the HP Jetdirect print server:
NONE: The print server is not connected to the network.
RJ-45: The RJ-45 network port is connected.
FIRMWARE VERSION Firmware revision number of the HP Jetdirect print server currently installed in the
printer.
LAA Locally administered address (LAA) identifies the specified LAN hardware address of
a print server, which is required by some network adiministrators. The default address
is the print server's factory-default LAN hardware address.
MANUFACTURING ID Manufacturing identification code for use by HP online support personnel.
S/N HP Jetdirect serial number.
DATE MANUFACTURED Manufacture date of the HP Jetdirect print server.
802.11 Wireless station settings
Wireless station status, configuration parameters and error messages are listed in Table 8-3 802.11
Wireless station settings on page 143.
142 Chapter 8 HP Jetdirect configuration pages ENWW