Administrator's Guide

Table 8-3 802.11 Wireless station settings (continued)
Message Description
SSL Version Version of the installed SSL protocol.
SSL Issuer Entity issuing the CA certificate.
SSL Subject Subject from the CA certificate.
SSL Start Date Date the SSL certificate is valid.
Encryption Type The type. 64–bit WEP, 128–bit WEP, Dynamic (used with WEP, TKIP, or both), Auto,
or None (no encryption is used)..
Dynamic Type Indicates whether dynamic encryption is used. Disabled, Shared (pre-shared keys), or
Robust (TKIP or AES)
Available Wireless Networks Lists the available wireless networks, and their properties which include the SSID,
Channel, Strength, Capability, Security, and BSSID.
Wireless Mode The 802.11 wireless mode, which are B/G or B/G/N.
Guard Interval The guard interval setting (Auto, Long or Short) which is the space between
transmitted symbols (characters). Can eliminate inter-symbol interference (ISI), which
occurs when echoes or reflections from one symbol interfere with another. A long
interval can reduce echoes, but decrease the data rate. A short interval can increase
the data rate by approximately 10 percent.
AMSDU Aggregation Aggregating 802.11n MAC service data units packs them into frames to reduce
overhead and increase the data rate. Enabling aggregation allows a maximum frame
size of 7935 bytes. Use aggregation of MAC service data units: ENABLED or
DISABLED
Block ACKs Select whether to enable acknowledgment of multiple AMPDUs, which allows each of
the aggregated data frames to be individually acknowledged or retransmitted if
affected by an error. (Automatically enabled when AMPDU Aggregation is enabled.)
Use block acknowledgement of multiple AMPDUs: ENABLED or DISABLED
AMPDU Aggregation Aggregating 802.11n MAC protocol data units packs them into frames to reduce
overhead and increase the data rate. Enabling aggregation allows a maximum frame
size of 64k bytes: ENABLED or DISABLED
Security Settings
Information in this section of the HP Jetdirect configuration page is described in the following table.
Table 8-4 Security Settings
Message Description
802.1X Indicates which EAP/802.1X client authentication setting was selected.
EAP-TLS Use EAP-TLS.
EAP-PEAP Use EAP-PEAP.
Specified An 802.1X authentication protocol other than EAP-TLS/EAP-PEAP was
selected.
Not Specified No 802.1X authentication was selected.
144 Chapter 8 HP Jetdirect configuration pages ENWW