Administrator's Guide

TCP/IP protocol information
Information in this section of the HP Jetdirect configuration page is described in the following table.
For general TCP/IP configuration parameters, see
Table 8-6 TCP/IP configuration information
on page 147. For IPv4 parameters, see Table 8-7 IPv4 Section on page 148. For IPv6 parameters,
see
Table 8-8 IPv6 Section on page 149. For error messages, see Table 8-13 Error messages
on page 153.
Table 8-6 TCP/IP configuration information
Message Description
IPv4
and
IPv6
Status of IPv4 and IPv6 protocols on the print server:
Enabled Protocol is active.
Disabled Protocol is inactive.
HOST NAME Host name configured on the print server. It might be truncated.
Not Specified Host name not specified in a BOOTP response or TFTP configuration
file.
NPIxxxxxx Default name is NPIxxxxxx, where xxxxxx represents the last six digits of
the LAN hardware (MAC) address.
IPV4 DOMAIN NAME DNS name of the IPv4 domain in which the HP Jetdirect print server resides (for
example, support.company.com). This is not the fully qualified DNS name (for
example, printer1.support.company.com) because the host printer name is not
included.
Not Specified Domain name not configured on the print server.
IPV6 DOMAIN NAME DNS name of the IPv6 domain in which the HP Jetdirect print server resides (for
example, support.company.com). This is not the fully qualified DNS name (for
example, printer1.support.company.com) because the host printer name is not
included.
Not Specified Domain name not configured on the print server.
PRIMARY DNS SERVER IPv4 address of the DNS server.
Not Specified Primary DNS server not configured on the print server.
SECONDARY DNS SERVER IPv4 address of the DNS server.
Not Specified Secondary DNS server not configured on the print server.
DNS (IPV6) IPv6 address of one or more DNS servers.
Not Specified IPv6 DNS server not configured on the print server.
WINS SERVER IP address of the WINS server.
Not Specified WINS server's IP address not detected or configured.
IDLE TIMEOUT Timeout value expressed in seconds after which the print server closes an idle TCP
print data connection. Values are integers between 0 and 3600. A value of zero turns
off the timeout mechanism. The default value is 270 seconds.
IPv4 section
Items displayed under the IPv4 section of the configuration page are discussed in the following table.
ENWW HP Jetdirect configuration page 147