Administrator's Guide

Table 8-13 Error messages (continued)
Error Code and Message Description
51 TFTP RETRIES EXCEEDED Retry limit exceeded when transferring the TFTP configuration file from the host to
the HP Jetdirect print server.
52 BAD BOOTP/DHCP REPLY Error detected in the BOOTP or DHCP reply received by the HP Jetdirect print server.
The reply contains insufficient data in the UDP datagram for the minimum BOOTP/
DHCP header of 236 bytes, has an operation field that is not BOOTPREPLY(0X02),
has a header field that does not match the print servers hardware address, or
contains a UDP source port that is not the BOOTP/DHCP server port (67/udp).
53 BAD BOOTP TAG SIZE Tag size in a vendor-specific field in the BOOTP reply is either 0, or greater than the
remaining number of unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP IN PROGRESS Print server is obtaining its basic IP configuration information through BOOTP/RARP.
55 BOOTP/DHCP IN PROGRESS HP Jetdirect print server is obtaining its basic IP configuration information through
BOOTP/DHCP (no errors detected).
56 DHCP NAK Print server received a negative acknowledgement message from the DHCP server in
response to a configuration request.
57 UNABLE TO CONNECT DHCP
SVR
The HP Jetdirect print server received IP parameters from a DHCP server, but
communication with the server is lost. Check status of the DHCP server.
If an infinite lease is assigned, the print server uses the IP address of the most recent
DHCP server. Operation can degrade until a DHCP server responds.
58 POSTSCRIPT MODE NOT
SELECTED
Printer does not support AppleTalk or AppleTalk extensions.
59 INCOMPLETE F/W - MUST
DOWNLOAD
Currently downloading firmware to the HP Jetdirect print server, or the download did
not complete properly.
5A TURN PRINTER OFF / ON Firmware download is complete. Turn the HP Jetdirect print server off and then on.
5C DHCP BAD REPLY Bad reply received from the DHCP server. Check your DHCP server settings for this
print server.
5D DHCP LEASE DURATION TOO
SHORT
DHCP lease times for this print server's TCP/IP configuration settings are too short.
Re-configure the DHCP lease times on the DHCP server.
5E DHCP LEASE RELEASED Lease parameters for DHCP, including the IP address, were released through a
manual configuration method, such as the printer's control panel.
5F WINS REGISTRATION FAILED Cannot register the print server's name on the WINS server. Check for duplicate
names, or verify the WINS server configuration.
61 AUTO IP CONFIGURED Cannot retrieve an IP address over the network. The print server defaults to an IP
address using link-local addressing in the form 169.254.x.x.
62 DEFAULT IP CONFIGURED Cannot retrieve an IP address over the network. The print server defaults to a legacy
IP address 192.0.0.192.
63 AUTO IP IN PROGRESS The print server is automatically assigning an IP address using link-local addressing
in the form 169.254.x.x.
64 INVALID PASSWORD An invalid password was specified through TFTP. Verify that the password consists of
a maximum of 16 printable characters.
65 DOWNLOAD NOT ALLOWED
ON WIRELESS
This print server does not allow firmware upgrade over a wireless network
connection.
83 DISCONNECTING FROM
SERVER
Server shut down because of a configuration change or reset request. This message
automatically clears after a few seconds, unless the printer is offline, is in an error
state, or is servicing another I/O port or another network protocol.
158 Chapter 8 HP Jetdirect configuration pages ENWW