Administrator's Guide

Table 8-13 Error messages (continued)
Error Code and Message Description
84 DHCP LEASE TIMERS
ADJUSTED
The print server detected a DHCP lease error due to one of the following conditions:
●
Renew time is less than 30 seconds.
●
Rebind time is less than 52 seconds.
● Rebind time is less than, or equal to, the Renew time.
●
Lease duration is less than, or equal to, the Rebind time.
F1 TRYING TO CONNECT TO
SERVER
The HP Jetdirect print server is attempting connection to the NetWare server(s). This
is a normal message. Wait until the connection is established or another status
message appears.
F2 TFTP IN PROGRESS The print server is attempting to use TFTP to obtain TCP/IP configuration settings
over the network.
F3 BOOTP/RARP IN PROGRESS The print server is attempting to use BootP or RARP to obtain TCP/IP configuration
settings over the network.
F4 BOOTP/DHCP IN PROGRESS The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration
settings over the network.
HP Jetdirect Security page
If the HP Jetdirect print server supports IPsec, you can print an enhanced Security page from the
HP Jetdirect menu that is accessed through the printer control panel. The following figure shows a
typical Security page:
NOTE: This section describes a typical security page. The actual security page content depends on
the HP Jetdirect product and the firmware version.
To print the HP Jetdirect Security Page:
1. On the printer control panel, navigate to the HP Jetdirect menus.
2. In the HP Jetdirect menus, locate and select the Security menu item.
3. In the Security menu, locate and select Print Sec Page. (This option is displayed only if IPsec is
supported by the print server.)
4. Click Yes to print the security page.
ENWW HP Jetdirect Security page 159