Administrator's Guide

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Configure Keys Transmit Key Displays if WEP selected.
Entry Method Format for WEP key entry.
Auto: Automatically generate a valid WEP key.
Alphanumeric: Alphanumeric ASCII characters (0–9,
a–z, A–Z). For 40/64-bit encryption, enter 5
characters. For 104/128-bit encryption, enter 13
characters. ASCII entries are case-sensitive.
HEX: Hexadecimal digits (0–9, a–f, A–F). For 40/64-
bit encryption, enter10 hexadecimal digits. For
104/128-bit encryption, enter 26 hexadecimal digits.
HEX entries are not case-sensitive.
Key (1 through 4) The print server can store up to four WEP keys using
four key positions (Key 1, 2, 3, 4). To enter a WEP
key, specify the key position followed by the
encryption key value.
Reset 802.11 Reset the wireless 802.11 settings to their default
values (Yes or No).
TCP/IP Enable Off: Disable the TCP/IP protocol.
On (default): Enable the TCP/IP protocol.
Host Name An alphanumeric string (up to 32 characters),
identifying the device. The default is NPIxxxxxx,
where xxxxxx is the last six digits of the LAN
hardware (MAC) address.
IPv4 Settings Config Method How TCP/IPv4 parameters are configured on the
HP Jetdirect print server.
BootP: Automatic configuration from a BootP server.
DHCP (default): Automatic configuration from a
DHCPv4 server. If a DHCP lease exists, use the
DHCP Release and DHCP Renew menus to set
DHCP lease options.
Auto IP: Automatic link-local IPv4 addressing. An
address in the form 169.254.x.x is assigned
automatically.
Manual: Manually configure TCP/IP4, using the
Manual Settings menu.
DHCP Release Displays if Config Method is set to DHCP and a
DHCP lease exists for the print server.
No (default): Current DHCP lease is saved.
Yes: Current DHCP lease and the leased IP address
are released.
ENWW Graphical control panel menus 181