Administrator's Guide

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
DHCP Renew Displays if Config Method is set to DHCP and a
DHCP lease exists for the print server.
No (default): Print server does not request to renew
the DHCP lease.
Yes: Print server requests to renew the current DHCP
lease.
Manual Settings Available if Config Method is set to Manual. You can
set the following from the printer control panel:
IP Address: Printer IP address.
Subnet Mask: Printer subnet mask.
Syslog Server: IP address of the syslog server used
to receive and log syslog messages.
Default Gateway: IP address of the gateway or router
used for communications with other networks.
Idle Timeout: Time, in seconds, after which an idle
TCP print data connection is closed.
Default IP Default IP address to use if the print server is unable
to obtain an IP address from the network during a
forced TCP/IP reconfiguration. (For example, when
manually configured to use BootP or DHCP.)
Auto IP: Link-local IP address 169.254.x.x is set.
Legacy: 192.0.0.192 is set, consistent with older
HP Jetdirect devices.
Primary DNS IP address (n.n.n.n) of a primary DNS server.
NOTE: Displays only if Manual configuration is a
higher priority than DHCP in the Config Precedence
table, when configured through the HP Embedded
Web Server.
Secondary DNS IP address (n.n.n.n) of a secondary DNS server.
NOTE: Displays only if Manual configuration is a
higher priority than DHCP in the Config Precedence
table, when configured through the HP Embedded
Web Server.
IPv6 Settings Enable IPv6 operation on the print server.
Off: Disable IPv6.
On (default): Enable IPv6.
Address Manually configure an IPv6 address.
Manual Settings: Manually configure a TCP/ IPv6
address.
Enable: Enable (On) or disable (Off) manual
configuration.
Address: IPv6 node address (32 hexadecimal digits).
182 Appendix C HP Jetdirect control panel menus (V.45.xx.nn.xx) ENWW