Administrator's Guide

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
DHCPv6 Policy Router Specified: Router determines the stateful auto-
configuration method used by the print server. The
print server obtains its address, its configuration
information, or both from a DHCPv6 server.
Router Unavailable: If a router is not available, the
print server obtains its stateful configuration from a
DHCPv6 server.
Always: Print server always attempts to obtain its
stateful configuration from a DHCPv6 server.
Primary DNS IPv6 address of the primary DNS server the print
server uses.
NOTE: Displays only if Manual configuration is a
higher priority than DHCP in the Config Precedence
table, when configured using the HP Embedded Web
Server.
Secondary DNS IPv6 address for a secondary DNS server that the
print server uses.
NOTE: Displays only if Manual configuration is a
higher priority than DHCP in the Config Precedence
table, when configured using the HP Embedded Web
Server.
Proxy Server Proxy server to use by embedded applications in the
device. A proxy server is typically used by network
clients for Internet access. The proxy server caches
Web pages and provides a degree of Internet
security.
Enter its IPv4 address or FQDN (up to 255 octets).
Contact your ISP for the proxy server address, when
required.
Proxy Port Port number used by the proxy server for client
support. This port is reserved for proxy activity on
your network, and can be a value from 0 to 65535.
IPX/SPX Enable Off: Disable the IPX/SPX protocol.
On: Enable the IPX/SPX protocol.
NOTE: The factory default setting depends on the
print server model.
Frame Type Frame-type setting for your network.
Auto: Sense all types and configure the first one
detected.
EN_8023, EN_II, EN_8022, and EN_SNAP: Frame-
type selections for Ethernet networks
ENWW Graphical control panel menus 183