Administrator's Guide

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Code Verification Yes (default): Perform verification of the integrity and
authenticity of the encrypted firmware upgrade image
before installation. If an error is detected by the
download manager, the configuration page displays a
code verification error.
No: Do not perform verification of the firmware
upgrade image.
Enable Wipe Most configuration settings are erased during a cold
reset. However, you can indicate whether to also
erase stored digital certificates.
Yes: Erase all stored digital certificates during a cold
reset.
No (default): Do not erase stored digital certificates
during a cold reset.
Login Security Keep
Reset
Assessment Keep
Disable
Diagnostics Embedded Tests (HP Jetdirect embedded print servers only.) Diagnose
network hardware or TCP/IP network connection
problems.
Use an embedded test to check hardware and
communication paths on the print server. After you
select and enable a test and set the execution time,
select Execute to initiate the test.
Depending on the execution time, a selected test runs
continuously until either the device is turned off, or an
error occurs and a diagnostic page is printed.
LAN HW Test CAUTION: Running this embedded test erases your
TCP/IP configuration.
Performs an internal loopback test, which sends and
receives packets only on the internal network
hardware. There are no external transmissions.
Yes: Select this test.
No: Do not select this test.
HTTP Test Check operation of HTTP by retrieving predefined
pages from the device, and test the HP Embedded
Web Server.
Yes: Select this test.
No: Do not select this test.
ENWW Graphical control panel menus 185