Administrator's Guide

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
SNMP Test Checks operation of SNMP communications by
accessing predefined SNMP objects on the device.
Yes: Select this test.
No: Do not select this test.
Data Path Test Identify data path and corruption problems on an HP
postscript level 3 emulation device. Sends a
predefined PS file to the device. However, the file
does not print (paperless).
Yes: Select this test.
No: Do not select this test.
Select All Tests Run all the embedded tests.
Yes: Run all tests.
No: Do not run all tests.
Execution Time [H] Specify the length of time (in hours) that an
embedded test runs, using a value from 1 to 60. If you
select zero (0), the test runs indefinitely until an error
occurs or the device is turned off.
Data gathered from the HTTP, SNMP, and Data Path
tests is printed after the tests complete.
Execute No (default): Do not run the selected tests.
Yes: Run the selected tests.
Ping Test Test network communications. Sends link-level
packets to a remote network host, then waits for an
appropriate response.
Dest Type Target device is an IPv4 or IPv6 node.
Dest IPv4 The IPv4 address.
Dest IPv6 The IPv6 address.
Packet Size Size of each packet, in bytes, sent to the remote host.
The minimum is 64 (default) and the maximum is
2048.
Timeout Length of time, in seconds, to wait for a response
from the remote host. The default is 1 and the
maximum is 100.
Count Number of ping test packets to send. Select a value
from 1 to 100. Enter zero (0) to run the test
continuously.
Print Results Print the test results (if not running continuously).
Yes: Print the results.
No (default): Do not print the results.
186 Appendix C HP Jetdirect control panel menus (V.45.xx.nn.xx) ENWW