Administrator's Guide

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Link Speed Set the print server's link speed. The available
settings depend on the device and installed print
server. Select one of the following modes:
Auto (default): Use auto-negotiation to configure the
highest link speed and communication mode allowed.
If auto-negotiation fails, either 100TX HALF or 10TX
HALF is set depending on the detected link speed of
the hub/switch port. (A 1000T half-duplex selection is
not supported.)
10T Half: 10 Mbps, half-duplex operation.
10T Full: 10 Mbps, full-duplex operation.
100TX Half: 100 Mbps, half-duplex operation.
100TX Full: 100 Mbps, full-duplex operation.
100TX Auto: Limits auto-negotiation to a maximum
link speed of 100 Mbps on 1000T networks.
1000TX Full: 1000 Mbps, full-duplex operation.
CAUTION: Changing the link setting can cause the
loss of network communication with the print server.
Print Protocols Print a page that lists the configuration of the following
protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC/
LLC.
188 Appendix C HP Jetdirect control panel menus (V.45.xx.nn.xx) ENWW