Administrator's Guide
Example HP Jetdirect TFTP configuration file
# Allow subnet 192.168.10.0 access
allow: 192.168.10.0255.255.255.0
#
# Disable Telnet
telnet-config: 0
#
# Enable the embedded Web server
ews-config: 1
#
# Detect SNMP unauthorized usage
auth-trap: on
#
# Send traps to 192.168.10.1
trap-dest: 192.168.10.1
#
# Specify the Set Community Name
set-cmnty-name: 1homer2
#
# End of File
Set allow to enable subnet 192.168.10.0 with access to the printer.
This specifies a host or network of hosts that can connect to the
print server. Add up to 10 entries using TFTP, Telnet, or the
HP Embedded Web Server. You can also specify single IP
addresses for specific systems. The following list describes the
example TFTP configuration file settings:
telnet-config Set to zero (0). Cannot use Telnet.
ews-config Set to one (1). Use the HP Embedded Web Server.
auth-trap Set to on. Send SNMP authentication traps.
trap-dest IP address of the system to send SNMP traps to.
set-cmnt-name Community name required in SNMP Set
commands.
This table describes the TFTP command parameters supported by HP Jetdirect print servers.
(Optional commands for the same function are shown in parentheses.)
Table 3-2 TFTP configuration file parameters
General
passwd: (or passwd-admin:)
Administrator's password to control access to HP Jetdirect print server configuration parameters using Telnet, HP Web
Jetadmin, or the HP Embedded Web Server. Enter up to 16 alphanumeric characters. Clear the password with a cold
reset.
sys-location: (or host-location:, location:)
Physical location of the printer (SNMP sysLocation object). Enter up to 64 alphanumeric characters. The default
location is undefined.
sys-contact: (or host-contact:, contact:)
Name of the network or device administrator (SNMP sysContact object) who administers or services the printer. Enter
up to 64 alphanumeric characters. The default contact is undefined.
26 Chapter 3 TCP/IP configuration ENWW