Administrator's Guide

NOTE: To view supported commands, formats, and parameters, type ?.
To list additional (or advanced) commands, type advanced before entering ?.
To display current configuration information, type /.
1. At the > Telnet prompt, type the following and press Enter:
<command parameter>: <value>
The <command parameter> signifies the configuration parameter, and <value> is the value
assigned to that parameter. Follow each command entry with Enter (carriage return).
See
Table 3-3 Telnet Commands and Parameters on page 42 for configuration parameters.
2. Repeat the previous step to set any additional configuration parameters.
3. When you have finished setting the configuration parameters, type exit or quit (depending on
your system).
Indicate whether to save any changes by entering Y (default) for Yes, or N for No.
If you enter save instead of exit or quit, you are not prompted to save settings.
Telnet commands and parameters.
Table 3-3 Telnet Commands and Parameters on page 42 lists
the available Telnet commands and parameters.
NOTE: If a parameter is dynamically provided by a BOOTP or DHCP server, you cannot change its
value unless you set Manual configuration. See the ip-config command.
When you manually set an IP address, you should also re-set the subnet mask and default gateway.
Table 3-3 Telnet Commands and Parameters
Command Description
User Control Commands
?
Display the Help and Telnet commands.
/
Display current values.
menu
Display the
Menu Interface on page 59 for use of the configuration parameters.
advanced
Enable advanced commands. Help (?) includes the advanced commands in the list.
general
Disable advanced commands. Help (?) does not include advanced commands (default).
save
Save the configuration values and exit the session.
exit
Exit the session.
export
Export the settings to a file for editing, and importing through Telnet or TFTP. (Only
available on systems that support input/output redirection, such as UNIX.)
General
42 Chapter 3 TCP/IP configuration ENWW