Administrator's Guide

Table 3-3 Telnet Commands and Parameters (continued)
ipx-sapinterval
Time in seconds that the HP Jetdirect print server waits between service advertising
protocol (SAP) broadcasts on the network. Set from 1 to 3600 seconds.
0: Disable.
60 (default): Enable SAP broadcasts.
ipx-mode
(Read-only parameter.) NetWare mode configured on the print server (RPRINTER or
QSERVER).
ipx-nds-tree
NDS tree name for the print server. Enter up to 31 alphanumeric characters.
ipx-nds-context
NDS context for the HP Jetdirect print server. Enter up to 256 alphanumeric characters.
ipx-job-poll Specifies the time interval in seconds that the HP Jetdirect print server waits to check for
print jobs in a print queue. Set from 1 to 255 seconds.
0: Disable.
2 (default): Enable.
pjl-banner
(ipx-banner)
Print an IPX banner page through PJL.
0: Disable.
1 (default): Enable banner pages.
pjl-eoj
(ipx-eoj)
IPX end-of-job notification through PJL.
0: Disable.
1 (default): Enable.
pjl-toner-low
(ipx-toner-low)
IPX toner-low notification through PJL.
0: Disable.
1 (default): Enable.
AppleTalk
appletalk
Use AppleTalk (EtherTalk) protocol operation on the print server.
0: Disable.
1 (default): Enable.
NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are
disabled by factory default.
Name
(Read-only parameter.) Name of the printer on the AppleTalk network. A number after
the name indicates that this is the Nth instance of the name.
Print Type
(Read-only parameter.) AppleTalk network printer type reported by the HP Jetdirect print
server. Up to three print types can be reported.
Zone (Read-only parameter.) Name of the AppleTalk network zone on which the printer is
located.
Phase
(Read-only parameter.) AppleTalk phase 2 (P2) is pre-configured on the HP Jetdirect
print server.
56 Chapter 3 TCP/IP configuration ENWW