Administrator's Guide

Table 3-3 Telnet Commands and Parameters (continued)
Status
(Read-only parameter.) Current AppleTalk configuration status.
READY: HP Jetdirect print server is awaiting data.
DISABLED: AppleTalk was manually disabled.
INITIALIZING: Print server is registering the node address or name. An additional
status message might also be displayed.
DLC/LLC
dlc/llc-config
Use DLC/LLC protocol operation on the print server (if supported).
0: Disable.
1 (default): Enable.
NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are
disabled by factory default.
strict-8022
Controls DLC/LLC protocol interpretation:
0 (default): Disable. Provide loose interpretation.
1: Enable. Provide strict interpretation.
Other
upgrade
Set the name and location of the firmware upgrade file for the HP Jetdirect print servers.
CAUTION: Ensure that command parameters are properly entered and that the
upgrade file is a higher version than the currently installed version. The print server
attempts to upgrade if the upgrade file contains a higher version than the installed
version.
The following is the command format:
upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
The following defines the parameters:
<TFTP Server IP> IP address of the TFTP server, <Version> firmware version of
the upgrade file, <Product Number> print server product number <Filename> path
and filename of the firmware upgrade file.
laa Specify a locally administered address (LAA) to replace the factory-assigned LAN
hardware (MAC) address. If LAA is used, enter a string of exactly 12 hexadecimal digits.
For Ethernet print servers, the LAA must start with hexadecimal X2, X6, XA, or XE,
where X is any hexadecimal digit 0 through F.
The default address is the factory-assigned address.
xml-services-conf
Allow access by HP Web service applications to XML-based data on the HP Jetdirect
print server.
0: Disable.
1 (default): Enable.
ws-discovery-conf
Allow Microsoft WS discovery protocols on the print server.
1 (default): Enable.
0: Disable.
ENWW IPv4 configuration 57