Administrator's Guide

TCP/IP Settings
The TCP/IP Settings menu provides access to the following tabs:
●
Summary tab on page 74
●
Network Identification tab on page 75
●
TCP/IP(v4) tab on page 76
●
TCP/IP(v6) tab on page 77
●
Config Precedence tab on page 78
●
Advanced tab on page 79
Summary tab
This tab provides a summary of the TCP/IP configuration. Items on this page are described in the
following table.
Table 4-4 TCP/IP Summary tab
Item Description
Host Name IP host name assigned to the device and stored on the HP Jetdirect print server.
To configure a host name, see the Network Identification tab.
IPv4 Status Status of the IPv4 protocol. You cannot disable IPv4 from the HP Embedded Web
Server in this release.
Fully Qualified Domain Name
(IPv4/IPv6)
Consists of the device's host name and domain name. Unless the network
administrator segments domains into separate IPv4 and IPv6 hosts, you can use the
FQDN on either IPv4 or IPv6 networks simultaneously.
IPv4 Address IPv4 address, subnet mask and default gateway for the print server.
Config By IPv4 parameters configured using: DHCP, BOOTP, Manual, or Auto IP.
DHCP Lease Time Duration of the DHCP IP address lease (in seconds) for the print server. Populated if
DHCP configuration is used.
IPv6 Status Status of the IPv6 protocol. Enable or disable using the HP Embedded Web Server.
Fully Qualified Domain Name
(IPv6 only)
Consists of the device's host name and domain name. Depending on the network
architecture, it can be the same as, or different from, the printer's IPv4 FQDN. If
assigned, it applies to the IPv6 network only.
74 Chapter 4 HP Embedded Web Server (V.45.xx.nn.xx) ENWW