Administrator's Guide

Table 4-9 TCP/IP Advanced tab (continued)
Item Description
Syslog Server (IPv4 only) IP address of a host computer that is configured to receive syslog
messages from the HP Jetdirect print server. If a syslog server is not specified, syslog
messages are disabled.
Syslog Protocol (IPv4 only) Select whether to transport syslog messages to the syslog server using
the TCP or UDP protocol.
Syslog Port (IPv4 only) Valid port number to use for transporting syslog messages to the syslog
server using the TCP or UDP protocol.
Syslog Maximum Messages (IPv4 only) Maximum number of syslog messages sent by the HP Jetdirect print
server per minute. Allows you to control the log file size. The default is 10 per minute.
If set to zero, no maximum number is defined.
Syslog Priority (IPv4 only) Filter syslog messages sent to the syslog server. Enter from 0 to 7, with 0
being the most specific and 7 being the most general. Only messages that are lower
than the specified filter level (that is, higher in priority) are reported. The default value
7 reports all syslog messages. A value of 8 disables syslog reporting.
Enable CCC Logging Select or clear the check box to enable (default) or disable HP customer care logging.
Network Settings
Use the Network Settings pages to set or change configuration parameters for IPX/SPX
on page 81, AppleTalk on page 82, DLC/LLC on page 83, and SNMP on page 83 protocols.
To assign a parameter setting, enter the desired value and click Apply.
NOTE: The features displayed depend on the print server. Value-featured print servers provide
limited protocol support.
IPX/SPX
Use the IPX/SPX tab to configure IPX/SPX parameters on the HP Jetdirect print server. IPX/SPX
protocols are used for operation on a Novell NetWare or compatible IPX/SPX network (such as a
Microsoft network). For a description of the items, see
Table 4-10 IPX/SPX tab settings on page 81.
CAUTION: If you are using direct-mode printing over IPX/SPX on a Microsoft network, do not
disable IPX/SPX.
For a Novell NetWare network:
●
Use the HP Embedded Web Server to select Queue Server Mode parameters in a Novell
Directory Services (NDS) environment.
●
Do not use the HP Embedded Web Server to create the NDS print server, printer, and queue
objects. Instead, use another tool or utility.
Table 4-10 IPX/SPX tab settings
Item Description
IPX/SPX Enable Select the check box to use IPX/SPX protocols.
ENWW Networking tab 81