Setup and Install

HP Jetdirect Menus for Graphical Control Panels
Newer printer/MFP devices support graphical control panels, which may consist of a numeric keypad,
navigation buttons and touch-screen displays.
For HP Jetdirect menus, graphical control panels typically display 18 characters on a line, and as
many as four lines at a time. In addition, scrolling may be supported to allow display of additional
lines.
Figure A-1 Example of Graphical Control Panel
?
MENUS
MENUS
+
XXXXXXXXXX
+ XXXXXXXXXXXX
+
XXXXXXXX
Table A-1 HP Jetdirect EIO Menu on Graphical Control Panel
Menu item Sub-menu item Sub-menu item Values and Description
Wireless Wireless Mode Wireless print server mode.
B/G Mode: Use 802.11b or g mode.
B/G/N Mode: Use 802.11b, g, or n mode.
Mode Wireless mode.
Ad Hoc: A direct wireless peer-to-peer connection to
all network nodes, without routing through an access
point.
Infrastructure: Wireless connection to an access point
(gateway, bridge, base station) that receives and
forwards network traffic between all network nodes.
SSID Name of the network (service set identifier) to which
the print server is connected.
Authentication Encryption level on the print server.
No Security: Positive validation of a device's
identification is not required for network access
unless the network requires EAP authentication.
WEP: Each device on the network is configured with
a shared secret WEP key which is required to gain
access to the network.
WPA-PSK: Wi-Fi protected access using a pre-
shared key.
Configure PSK Pass-Phrase Displays if WPA-PSK is selected for authentication.
The Passphrase to use when generating the pre-
shared key for WPA-PSK authentication on your
network. A passphrase must be from 8 to 63 ASCII
characters in the hexadecimal range 21 through 7E
(characters 0–9, a–z, A–Z and numerous special
characters including !, @, #, $, %, ^, &, (, ), _, +, =, −,
{, }, [, ], \, /, “, <, >, ?, “, ‘, ˜).
22 Appendix A HP Jetdirect EIO Control Panel Menus ENWW