Setup and Install

Table A-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Configure Keys Transmit Key Displays if WEP selected.
Entry Method Format for WEP key entry.
Auto: Automatically generate a valid WEP key.
Alphanumeric: Alphanumeric ASCII characters (0–9,
a–z, A–Z). For 40/64-bit encryption, enter 5
characters. For 104/128-bit encryption, enter 13
characters. ASCII entries are case-sensitive.
HEX: Hexadecimal digits (0–9, a–f, A–F). For 40/64-
bit encryption, enter10 hexadecimal digits. For
104/128-bit encryption, enter 26 hexadecimal digits.
HEX entries are not case-sensitive.
Key (1 through 4) The print server can store up to four WEP keys using
four key positions (Key 1, 2, 3, 4). To enter a WEP
key, specify the key position followed by the
encryption key value.
Reset 802.11 Reset the wireless 802.11 settings to their default
values (Yes or No).
TCP/IP Enable Off: Disable the TCP/IP protocol.
On (default): Enable the TCP/IP protocol.
Host Name An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host
name is NPIxxxxxx, where xxxxxx is the last six digits
of the LAN hardware (MAC) address.
IPV4 Settings Config Method Specifies the method that TCP/IPv4 parameters will
be configured on the HP Jetdirect print server.
Bootp: Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
DHCP (default): Use DHCP (Dynamic Host
Configuration Protocol) for automatic configuration
from a DHCPv4 server. If selected and a DHCP lease
exists, DHCP Release and DHCP Renew menus are
available to set DHCP lease options.
Auto IP: Use automatic link-local IPv4 addressing. An
address in the form 169.254.x.x is assigned
automatically.
Manual: Use the Manual Settings menu to configure
TCP/IPv4 parameters.
DHCP Release This menu appears if Config Method was set to
DHCP and a DHCP lease for the print server exists.
No (default): The current DHCP lease is saved.
Yes: The current DHCP lease and the leased IP
address are released.
ENWW HP Jetdirect Menus for Graphical Control Panels 23