Setup and Install

HP Jetdirect Menus for Classic Control Panels
Classic control panels can typically display two lines of 16 characters each. You must use the
available device keys to display and select HP Jetdirect settings. Typically, an asterisk (*) is used to
identify the selected value.
Figure A-2 Example of Classic Control Panel
Table A-2 HP Jetdirect EIO Menu on Classic Control Panel
Menu Item Description
CFG NETWORK Selects whether or not you want to access the HP Jetdirect menu.
NO (default): Bypass the HP Jetdirect menu.
YES: Access the HP Jetdirect menu. You must change this to YES* each time you want to
access the menu.
TCP/IP
IPX/SPX
DLC/LLC
ATALK
Identifies whether the protocol stack is enabled or disabled.
ON: The protocol is enabled.
OFF: The protocol is disabled.
NOTE: The factory default setting is Off.
CFG TCP/IP Selects whether you want to access the TCP/IP menu and set TCP/IP protocol parameters.
NO (default): Bypass the TCP/IP menu items.
YES: Access the TCP/IP menu items.
●
BOOTP=YES* enables IPv4 configuration by a BootP Server.
● DHCP=YES* enables IPv4 configuration by a DHCP Server.
If DHCP=YES* and the print server has a DHCP lease, you can choose to configure the
following DHCP settings:
◦
RELEASE: Choose YES to release, or NO to save, the current DHCP lease.
◦
RENEW: Choose YES to renew the current DHCP lease, or NO to not renew the
DHCP lease.
●
AUTO IP=YES* will automatically assign a link-local IPv4 address in the form
169.254.x.x.
28 Appendix A HP Jetdirect EIO Control Panel Menus ENWW