Administrator's Guide

NOTE: The information displayed depends on the HP Jetdirect print server and device. Value-featured
print servers provide limited information and capabilities.
Table 4-2 Networking Menu Items
CONFIGURATION section
●
Wireless on page 69
●
TCP/IP Settings on page 74
●
Network Settings on page 81
●
Other Settings on page 85
●
Select Language on page 91
SECURITY section
●
Security: Settings on page 91
●
Authorization on page 94
●
Mgmt. Protocols on page 99
●
802.1X Authentication on page 101
●
IPsec/Firewall on page 103
DIAGNOSTICS section
●
Network Statistics on page 104
●
Protocol Info on page 104
●
Configuration Page on page 104
Wireless
NOTE: You can use HP Jetdirect wired/wireless print servers in a wired or wireless networking
environment. To specify the connection type, see
Misc. Settings on page 85.
Use the Wireless pages to create or change your wireless network configuration parameters for your
IEEE 802.11 wireless Ethernet connection.
The configuration parameters are summarized in
Table 4-3 Wireless configuration parameters
on page 70.
The Wireless page displays all wireless configuration parameters required to make a wireless
connection to your network. Click Apply to set, or Cancel to ignore, your configuration entries. To
reset to factory-default values, click Restore Defaults.
Alternatively, you can click the Wireless Wizard button in the General section of the Wireless page
to configure your wireless network connection. This launches a configuration wizard that guides you
through the required 802.11 wireless configuration parameters and, depending on your choices,
bypasses unnecessary parameters.
Networking tab
69