HP EliteDesk 800 G1 Desktop Mini HP ProDesk 600 G1 Desktop Mini Maintenance & Service Guide

●

POST Delay (in seconds). Enabling this feature will add a user-specified delay to the POST

process. This delay is sometimes needed for hard disks on some PCI cards that spin up very

slowly, so slowly that they are not ready to boot by the time POST is finished. The POST delay

also gives you more time to select F10 to enter Computer (F10) Setup. Default is None.

●

Remote Wakeup Boot Source (remote server/local hard drive). Default is Local hard drive.

●

Factory Recovery Boot Support (Enable/Disable). Provides the ability for the BIOS to redirect

the boot to the recovery partition on the user hard drive, if present. Some versions of the

recovery software honor the F11 key press even when this feature is disabled by the BIOS.

Default is disabled.

●

Bypass F1 Prompt on Configuration Changes (Enable/Disable). Allows you to set the computer

not to confirm when changes were made. Default is disabled.

●

POST Memory Manager Runtime Allocation (Enable/Disable). Default is disabled.

BIOS Power-On Allows you to set the computer to turn on automatically at a time you specify.

Onboard Devices Allows you to set resources for or disable Legacy devices.

Select the Legacy device's IRQ, DMA, and I/O Range. The settings may not take effect for all

operating systems. To hide a device from the operating system, see Security > Device Security.

Bus Options Allows you to enable or disable:

●

PCI SERR# Generation. Default is enabled.

●

PCI VGA Palette Snooping, which sets the VGA palette snooping bit in PCI configuration

space; only needed when more than one graphics controller is installed. Default is disabled.

Device Options Allows you to set:

●

Num Lock State at Power-On (off/on). Default is off.

●

Internal Speaker (does not affect external speakers). Default is enabled.

●

Multi-Processor (enable/disable). Use this option to disable multi-processor support under the

OS. Default is enabled.

●

USB Charging Port (enable/disable). Default is enabled.

●

USB 3.0 BIOS Driver Support (enabled/disabled). Default is disabled.

●

Hyper threading (enable/disable). Use this option to disable processor hyper-threading.

Computer Setup (F10) Utilities