User Guide - Windows 7

If you add or upgrade a hard drive and intend to set a RAID volume, you must temporarily disable
SRT, set the RAID volume, and then enable SRT. To temporarily disable SRT:
1. Select Start > All Programs > Intel > Intel Rapid Storage Technology.
2. Click the Acceleration link, and then click the Disable Acceleration link.
3. Wait for the Acceleration Mode to complete.
4. Click the Reset to Available link.
IMPORTANT: You must temporarily disable SRT when changing RAID modes. Make the change
and then re-enable SRT. Failure to temporarily disable this feature will prevent you from creating or
changing RAID volumes.
NOTE: HP does not support SRT with self-encrypting drives (SEDs).
Removing or replacing the service door
Removing the service door
Remove the service door to access the hard drive and other components.
1. Remove the battery (see Inserting or removing the battery on page 35).
2. With the battery bay away from you, remove the screw (1), tilt the service door up (2), and then
lift the service door away (3).
Replacing the service door
Replace the service door after accessing the hard drive and other components.
44 Chapter 8 Drives