HP EliteDesk 705 G1 Microtower HP EliteDesk 705 G1 Small Form Factor HP EliteDesk 705 G1 Desktop Mini - Maintenance and Service Guide

Drive power cable
1. Prepare the computer for disassembly (Preparation for disassembly on page 36).
2. Remove the computer access panel (
Access panel on page 37).
3. Disconnect the cable from the optical drive (1) and the hard drive (2)
4. Remove the cable from the clips on the base pan and on the side of the hard drive cage (3).
5. Disconnect the cable from the system board connector labeled SATAPWR0 (4), and then remove the
cable from the computer.
To reinstall the drive power cable, reverse the removal procedure.
58 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis