Maintenance and Service Guide HP ProDesk 400 G1 Microtower HP ProDesk 480 G1 Microtower HP ProDesk 490 G1 Microtower HP ProDesk 400 G1 Small Form Factor

9. Press the tab on the right side of the assembly (2) to disengage it from the chassis.
10. Push the assembly into the chassis, and then remove it from the chassis.
To install the assembly, insert the assembly from the inside of the chassis, and then pull the tab on the
left side of the assembly out the front of the chassis. Push the right side until it clicks into place.
NOTE: Be sure to correctly route the cables beneath the drive cage when reinstalling the assembly.
Proper cable routing prevents damage to the cables and allows the drive cage to close properly.
124 Chapter 6 Removal and replacement procedures: Small Form Factor