HP ProBook 440 Notebook PC and HP ProBook 445 G2 Notebook PC - Maintenance and Service Guide

a. Service doors (see Service door on page 37).
b. Keyboard (see Keyboard on page 49)
c. Hard drive (Hard drive on page 39)
d. Optical drive (Optical drive on page 43)
e. Top cover (see Top cover on page 53)
Remove the card reader board:
NOTE: Before you remove the card reader, make sure nothing (memory card or plastic insert) in installed.
1. Position the top cover upside-down.
2. Disconnect the cable from the board (1).
3. Remove the two Phillips PM2.5×4.0 screws (2) that secure the card reader board to the computer.
4. Remove the card reader board from the top cover (3).
Reverse this procedure to install the card reader board.
64 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts