Quick Specs

QuickSpecs
HP Z230 SFF Workstation
Technical Specifications - Networking and Communications
c04123122 — DA - 14630 Worldwide — Version 26 — October 1, 2015
Page 50
Integrated Intel I217LM
PCIe GbE Controller (Intel
vPro with Intel AMT 9.0)
Connector
RJ-45
Controller
Intel I217LM GbE platform LAN connect networking controller
Memory
3 KB Tx and 3KB Rx FIFO packet buffer memory
Data Rates Supported
10/100/1000 Mbps
Compliance
802.1as/1588, 802.1p, 802.1Q, 802.3, 802.3ab, 802.3az, 802.3i, 802.3u,
802.3z
Bus Architecture
PCI Express and SMBus
Data Transfer Mode
PCIe-based interface for active state operation (S0 state) and SMBus for
host and management traffic (Sx low power state)
Power Requirement
Requires 3.3V (integrated regulators for core Vdc)
Boot ROM Support
Yes
Network Transfer Mode
Full-duplex; Half-duplex (not supported for the 1000BASE-T transceiver)
Network Transfer Rate
10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
Management Capabilities
vPro, WOL, auto MDI crossover, PXE, iSCSI Boot, Muti-port teaming, RSS,
ACPI, Advanced cable diagnostic, loopback modes,
AMT 9.0 support, Circuit Breaker, VLAN, Multicast Listener Discovery (MLD)
Intel 7260 802.11
a/b/g/n PCIe WLAN NIC
Operating Humidity
Operating: 10% to 90% (non-condensing)
Non-operating: 5% to 95% (non-condensing)
Dimensions (H x W x D)
Native HMC: 26.8 x 30.0 x 2.4 mm
Carrier Card Assembly 3.3 x 4.7 in (84 x 119 mm)
Kit Contents
PCIe x1 card with full height bracket, rf antenna, antenna cable, separate
low profile bracket, software CD and warranty.
NOTES
1. WLAN supplier's client utility is required for Cisco Compatible
Extensions support with Microsoft Windows XP. WLAN may also be
compatible with certain third-party software supplicants. WLAN
supplier IHV extensions required for Cisco Compatible Extensions
support for Microsoft Windows Vista.
2. Check latest software/driver release for updates on supported
security features.
3. Maximum output power may vary by country according to local
regulations.
4. In Power Save Polling mode and on battery power.
5. Receiver sensitivity is measured at a packet error rate of 8% for
802.11b (CCK modulation) and a packet error rate of 10% for
802.11a/g (OFDM modulation).