User Guide

150 Chapter 5 - Removal and replacement EN

Motor

Note You might find it easier to remove the ECU pan (see page 164)

before you remove the motor.

1 Separate the scanner from the printer (see pages 113 through

118) and remove the left side door and back cover (pages 129

and 130).

2 Remove the fuser assembly (see page 144).

3 Disconnect the motor cable connector (callout 1) on the side of

the motor.

4 Remove the two screws (callout 2) from the motor and remove

the motor.

Figure 68. Removing the motor

To reinstall

Make sure that the motor is in the correct position. The connector

should face the inside of the printer.