User Guide

EN Errors 179
### Is Empty
[Enter] To Add
The one-touch key or speed-dial
code has not been programmed
and therefore cannot be added to
a group.
Press
menu/enter to program the one-
touch or speed-dial. If you want to
program a group-dial, press
cancel and
use the control panel menu to create a
new group. Press
cancel if you do not
want to program the one-touch or speed-
dial.
###: [Group Name]
Phbook/SpeedDial
The product is waiting for you to
press a programmed one-touch
key or enter a speed-dial code to
a group-dial code.
Begin adding fax numbers to the group-
dial code. See “Programming group-dial
codes” in the User Guide on the product
CD.
Canceled Copy.
Clear Document
The cancel key was pressed to
cancel the current job while
pages were feeding from the
document feeder. The cancel
process will not automatically
clear the document feeder.
Pull the document release door open,
remove the jammed item, and close the
door. Then, clear the items in the
document feeder tray and start over.
Canceled Scan.
Clear Document
The cancel key was pressed to
cancel the current job while
pages were feeding from the
document feeder. The cancel
process will not automatically
clear the document feeder.
Pull the document release door open,
remove the jammed item, and close the
door. Then, clear the items in the
document feeder tray and start over.
Canceled Send.
Clear Document
The cancel key was pressed to
cancel the current job while
pages were feeding from the
document feeder tray. The cancel
process will not automatically
clear the document feeder.
Pull the document release door open,
remove the jammed item, and close the
door. Then, clear the items in the
document feeder tray and start over.
Comm. Error
Fax communication error
occurred between the product
and the sender or receiver. For
descriptions of communication
errors see table 22, “Fax receive
error codes,” on page 211, and
table 23, “Fax send error codes,”
on page 216.
Allow the product to retry sending the
fax.
Unplug the product telephone cord from
the wall, plug in a telephone, and try
making a call.
Plug the product phone cord into a jack
for another phone line.
Try a different phone cord.
If the error persists, check the flat flexible
cable between the LIU and the formatter.
Reseat or replace the cable.
If the error persists, replace the LIU.
Device Busy.
Try Again Later
The product is currently in use. Wait for the product to finish the current
job.
Device Error.
[Enter] To Cont.
There was an internal error in the
product.
Press menu/enter to resume the job.
Table 16. Alert and warning messages (continued)
Message Possible causes Solutions