User Guide

EN Service mode functions 233
NVRAM init
NVRAM init sets all stored parameters in NVRAM back to factory
default values or to a default ROM value, depending on the variable,
and performs a system reset.
CAUTION Performing NVRAM init can cause the product to violate local
telephone regulations. Reset the language and country code after
performing NVRAM init.
NVRAM init resets the following:
 All menu settings to factory default values, including fax header
and company name
 Factory settings such as formatter number, page counts, and
factory paper settings
 Fax memory—all faxes in memory are erased
 All localization settings, including language and country code
To perform NVRAM init
1 Unplug (or turn off) the product from the power source.
2 Press and hold down the * and menu/enter keys.
3 Continue to hold down the keys while you plug back in (or turn
on) the product, through the entire power on sequence.
4 When the control panel display reads Permanent Storage
Init. release the keys.
5 Allow the product to return to Ready before using the product.
PJL software commands
You can use PJL software commands to set the following NVRAM
variables:
Factory printer DEFAULT PAPER, scanner factory default paper size
will be set to the same value automatically.
Factory printer DEFAULT LPARM:PCL SYMSET
Factory DEFAULT OEM bit
Factory DEFAULT PRINTPAGECOUNT
Factory DEFAULT SCANPAGECOUNT
Factory DEFAULT COPYPAGECOUNT