User Guide

38 Chapter 2 - Operation EN
Control panel error messages
These control panel error messages are listed alphabetically.
Messages are accompanied by the cause of the message and user-
level steps to resolve the problem.
Table 10. Control panel error messages
Message Cause Solution
Cleaning Mode.
Wait 1-3 Min.
The product is running an internal
cleaning cycle.
Wait for the product to finish the
cleaning cycle. The message will
clear when the cycle is finished.
Fax Busy.
Canceled Send
The fax line to which you were
sending a fax was busy. The
product has cancelled sending
the fax.
Call the recipient to ensure that
the fax machine is on and ready.
Check that you are dialing the
correct fax number.
Check that the redial on busy
option is enabled.
Unplug the product telephone
cord from the wall, plug in a
telephone, and try making a call.
Plug the product phone cord into
a jack for another phone line.
See chapter 6, “Troubleshooting.
”
### Is Empty
[Enter] To Add
The one-touch key or speed-dial
code has not been programmed
and therefore cannot be added to
a group.
Press
menu/enter to program
the one-touch or speed-dial. If
you want to program a group-
dial, press
cancel and use the
control panel menu to create a
new group. Press
cancel if you
do not want to program the one-
touch or speed-dial.
###: [Group Name]
Phbook/SpeedDial
The product is waiting for you to
press a programmed one-touch
key or enter a speed-dial code to
a group-dial code.
Begin adding fax numbers to the
group-dial code. See
“Programming group-dial codes”
in the User Guide on the product
CD.
50 Fuser Error
The product has experienced an
internal hardware error.
Disconnect the power cable from
the product, wait at least 20
minutes, then reconnect the
power cable and wait for the
product to initialize. Try another
power source. If the message
does not clear, see chapter 6,
“Troubleshooting.”