User Guide

44 Chapter 2 - Operation EN
No Fax Detected
The product answered the
incoming call but did not detect
that a fax machine was calling.
Allow the product to retry
receiving the fax.
Unplug the product telephone
cord from the wall, plug in a
telephone, and try making a call.
Plug the product phone cord into
a jack for another phone line.
See chapter 6,
“Troubleshooting.”
No Fax Pages
To Reprint
The product attempted to
execute “Reprint Last Fax” when
nothing was in memory.
Receive a fax before attempting
to use this option.
Not Enough
Memory.Try Later
There is not enough memory to
start a new job.
Wait until the current job is
finished before starting a new
job.
Out of Range
An invalid number was entered. Correct the entry.
Printer Jam.
Clear Paper Path
The product has detected that a
jam has occurred.
Clear the jam. The job should
continue to print. If it does not, try
reprinting the job.
Printer Mispick
[Enter]To Resume
The print engine has failed to
pick up a piece of media.
Reload the paper in the paper
input tray and press
menu/enter
to continue the job.
Printer Tray Is
Empty.Add Paper
The paper input tray is empty. Load media. If media is already
loaded, remove it. Check for and
remove any jam, and then reload
the stack of media in the paper
input tray.
Scanner Bulb Failure
The scanner assembly
experienced an error in scanner
bulb functionality.
Disconnect the power cable from
the product, wait at least 30
seconds, then reconnect the
power cable and wait for the
product to initialize. Try another
power source. If the message
does not clear, see chapter 6,
“Troubleshooting.”
Scanner Reserved
For PC Scan
The product is being used to
create a scan by a computer.
Wait until the PC scan has
finished, or cancel the scan from
the computer software, or press
cancel.
Scanning Error.
Cannot Connect
The product cannot transmit scan
information to a computer.
Check the connection cable and
try the scan again.
Settings Cleared
The product has cleared job
settings.
Reenter any desired job settings.
Time/Date is in Past.
Try Again
Invalid date or time entry. Enter the correct time or date.
Table 10. Control panel error messages (continued)
Message Cause Solution