User Guide

Fuser
WARNING! The fuser might be very hot. After turning off the printer power, allow the fuser to
cool for at least 30 minutes before removing it.
1 Remove the rear output bin. See Rear output bin.
2 Squeeze the blue fuser-release tabs (callout 1).
3 Pull the fuser (callout 2) straight back and out of the printer.
Figure 6-6 Fuser
CAUTION Do not drop or jar the fuser. It can easily be damaged if it is mishandled.
Hint When you replace the fuser, make sure that it is fully seated into the printer. You should
hear both sides snap into place.
178 6 Removing and replacing parts