User Guide

Reinstallation tip The firmware DIMM must be installed in slot 1 (formatter PCA location J1;

topmost slot).

If you are installing additional DIMMs, the second DIMM must be installed in slot 2 (formatter

location J2; second slot down from the top). If another DIMM is installed, the third DIMM must

be installed in slot 3 (formatter location J3; third slot down from the top). If another DIMM is

installed, the fourth DIMM must be installed in slot 4 (formatter location J4; bottom slot). The

printer will not recognize DIMMs if they are not installed in the correct order.

Formatter assembly

NOTE Print a menu map and a configuration page. See Configuration page. Use the

information on the configuration page to restore any user-set product configuration options

after you install a replacement formatter. If you cannot print a configuration page, ask the

customer for a recent configuration page.

1 Remove the formatter cover. See Formatter cover.

2 Remove two screws (callout 1).

Figure 6-37 Formatter assembly (1 of 2)

Main assemblies 211