User Guide

3 Slide the shaft lock to the right and remove it to release the gear shaft from the output-delivery
assembly (callout 2).
CAUTION Do not break the shaft lock. A replacement is not provided with a new output-
delivery assembly.
Figure 6-39 Output-delivery assembly (1 of 2)
Hint Snap the shaft lock back into place on the assembly so that you will not lose it.
Remove the shaft lock when you reinstall the output-delivery assembly. When the output-
delivery assembly is installed, verify that the locking pin on the shaft lock is fully seated in
the hole on the output-delivery assembly.
CAUTION The rear face-down output-bin-sensor cable (callout 3) is routed through a
notch (callout 4) on the output delivery system at the gear end of the assembly. When you
remove the assembly, carefully remove the cable from the notch to avoid damage to the
cable.
Main assemblies 215