User Guide

Tray 2 lifter-drive assembly
1 Remove the following assemblies:
● Rear accessory cover. See
Accessory covers and the tray 2 extension door.
● Top cover. See
Top cover.
● Right-side cover. See
Right-side cover.
● Formatter cover. See
Formatter cover
● Formatter. See
Formatter assembly
● Paper-pickup drive assembly. See
Paper-pickup drive assembly.
2 Unplug the tray 2 lifter-drive assembly connector from the dc controller PCA (location J93) and
the two flat cables (callout 1, locations J80, J81). Unweave the wire-harness from the cable
guide (callout 2).
NOTE You might have to remove additional wire-harnesses from the cable guide to gain
access to the lifter-drive assembly wire-harness.
Figure 6-51 Tray 2 lifter-drive assembly (1 of 3)
Main assemblies 227