User Guide

5 Unplug the two power-supply flat cables and the dc controller power connector from the
dc controller (locations J80, J81, and J99). Unweave the wire-harness and cables from the cable
guide.
Hint You might have to remove additional wire-harnesses from the cable guide to gain
access to the power-supply harness.
CAUTION Note the position of the flat cables and power cables through the bottom of
the cable guide. Failure to route these cables correctly through the bottom of the cable
guide might result in interference with the tray 2 lifter-driver assembly, and the cables
might be damaged during printer operation.
Figure 6-61 Power-supply assembly (3 of 7)
238 6 Removing and replacing parts