User Guide

Pickup and feed assemblies
Tray 1 paper-pickup assembly
1 Remove the following assemblies:
● Rear accessory cover. See
Accessory covers and the tray 2 extension door.
● Top cover. See
Top cover.
● Right-side cover. See
Right-side cover.
● Formatter cover. See
Formatter cover
● Left-side cover. See
Left-side cover.
● Tray 1. See
Tray 1.
2 Gently pry back the two retaining tabs (callout 1) and slip the anti-static bar (callout 2) off of
them. Rotate the anti-static bar away from the printer to release it. Remove the anti-static bar.
3 Unplug the tray 1 pickup solenoid connector and the top-cover sensor connector from the
dc controller PCA (locations J79 and J95). Unweave the harnesses from the wire guide (callout 3).
Hint You might have to remove additional wire-harnesses from the wire guide to gain
access to the solenoid and sensor harnesses.
1
2
3
Figure 6-78 Tray 1 paper-pickup assembly (1 of 4)
Pickup and feed assemblies 257